DZA(S) 80-65-125 4kW End-Suction Pump with Motor (Stainless Steel)

The DZA(S) 80-65-125 is a flanged end-suction centrifugal pump with a 304 stainless-steel pump end, supplied here as a complete set with a 4kW (5.5HP) electric motor. It is built for continuous duty: farm and orchard irrigation, dam and reservoir transfer, water supply to buildings, HVAC and cooling-water circulation, and general industrial water.

• Size 80-65-125: 80mm suction flange, 65mm delivery flange, 125mm nominal impeller
• Motor: 4kW (5.5HP), 2-pole (about 2900 rpm)
• Head: 18m at 36 m³/h, falling to 4.5m at 108 m³/h
• Maximum flow: about 108 m³/h (1800 l/min)
• Pump casing and impeller: 304 stainless steel – suited to clean or slightly aggressive water

Motor options:

• With 380V three-phase motor – code 15070091
• With 525V three-phase motor – code 15070092

Pump end only (no motor) is also available: bareshaft code 15070037.

Performance Table:

Will this pump suit my job? Add up the height the water must be lifted (from the water level to the highest outlet) plus about 1m for every 10m of pipe and fittings – that is your total head. Then find your flow in the table: the pump is a good match if the head at your flow is at or just above what you need. This model works best around 60 m³/h at 14m. 380V and 525V motors need a three-phase supply and a suitable starter/overload; 220V motors run on normal household single-phase power. Not sure? Send us your flow, lift and pipe length and we will size it for you.